Description

This mounting option is recommended for situations when you need a lab support lattice to cover the entire back panel of your fume hood. The horizontal rods of this Lab-Frame should measure 1/4” less than the interior width of your hood.

Assembly Instructions:

Lattice frame: Use the open connectors and lattice rods to assemble the frame. The kit assumes a lattice spacing of 1-foot; however, this may vary depending on your application. Rods may be cut for fit as necessary.

Mounting: Attach vertical base plates to the horizontal and vertical rod ends. Base plates may be secured with #10 screws. Mounting Screws Not Included.

NOTE: Follow your fume hood manufacturers’ requirements for attachment.

4 foot Kit Includes:

(3) 1/2″ X 36″ Fiberglass Rod
(2) 1/2″ X 38″ Fiberglass Rod
(6) PL2A-1C Connectors
(7) PL8A-1 Vertical Base Plates
(1) Assembly Instructions

6 foot Kit Includes:

(5) 1/2″ X 36″ Fiberglass Rod
(2) 1/2″ X 62″ Fiberglass Rod
(10) PL2A-1C Connectors
(9) PL8A-1 Vertical Base Plates
(1) Assembly Instructions

8 foot Kit Includes:

(7) 1/2″ X 36″ Fiberglass Rods
(2) 1/2″ X 86″ Fiberglass Rods
(14) PL2A-1C Connectors
(11) PL8A-1 Vertical Base Plates
(1) Assembly Instructions